The largest online repair guide library for every car

About us
Contact support
FAQ
Sign up
Sign in

DPF Full Warning on my 2018 Discovery Sport - What's going on?

0

David L. · rep 0 · May 22, 6:28 AM · 1 replies · solved · Question

Vehicle: 2018 Land Rover Discovery Sport HSE

Hey everyone,

I'm looking for some advice regarding my 2018 Land Rover Discovery Sport HSE, which has the 2.0L Ingenium diesel engine. Lately, I've been getting a 'DPF Full' warning message on my dashboard, and a couple of times, the car has even gone into limp mode, which is pretty concerning.

I primarily use the car for short commutes around town, with occasional longer trips on the highway. I've read a bit about DPFs, but I'm not entirely sure what I should be doing when this warning comes up. Is there a specific driving pattern I should follow, or does this mean I need to take it to the dealer immediately?

Any insights or similar experiences with your Discovery Sport would be greatly appreciated. I want to avoid any costly repairs if possible, but also ensure I'm not damaging the engine by ignoring this.

✓ Accepted solution

ClearTheCode Admin

ClearTheCode Team · rep 0 · May 22, 6:28 AM

0

ClearTheCode admin answer:

The Diesel Particulate Filter (DPF) is a crucial component in your 2018 Land Rover Discovery Sport's exhaust system, designed to capture soot and harmful particulates from the diesel engine's exhaust gases. When the DPF gets full, it needs to regenerate, which is a process of burning off the accumulated soot.

Here's what's likely happening and what you can do:

  1. Understanding DPF Regeneration: Your vehicle's DPF performs two types of regeneration: passive and active. Passive regeneration occurs naturally during sustained high-speed driving (e.g., highway driving) when exhaust temperatures are high enough to burn off soot. Active regeneration is initiated by the engine's computer when passive regeneration isn't sufficient, injecting fuel to raise exhaust temperatures.

  2. Causes of 'DPF Full' Warning: Your primary use for short city commutes is a common cause. Short trips often don't allow the engine to reach the necessary temperatures or sustain them long enough for either passive or active regeneration cycles to complete successfully. This leads to soot accumulation and the 'DPF Full' warning.

  3. Initial Action (Owner-initiated Regeneration):

    • If you receive a 'DPF Full' warning but are not in limp mode, try to perform an owner-initiated regeneration. Drive your Discovery Sport at a consistent speed of at least 40 mph (60 km/h) for 20-30 minutes. This helps raise exhaust temperatures and allows the DPF to complete a regeneration cycle. Ensure your fuel tank is at least a quarter full.

  4. When to See a Shop:

    • Persistent Warning or Limp Mode: If the 'DPF Full' warning persists after attempting an owner-initiated regeneration, or if your vehicle enters limp mode, it's crucial to take it to a qualified Land Rover service center immediately. Continuing to drive with a full DPF can lead to more severe damage, including a completely blocked DPF or even engine issues.
    • Diagnostic Trouble Codes (DTCs): A shop will be able to read specific OBD-II codes related to the DPF. Common codes include:
      • P2002: Diesel Particulate Filter Efficiency Below Threshold (Bank 1)
      • P2463: Diesel Particulate Filter Restriction - Soot Accumulation
      • P242F: Diesel Particulate Filter Restriction - Ash Accumulation
    • Shop Solutions: The service center can perform a forced regeneration using specialized diagnostic equipment. If the DPF is too heavily clogged, they might recommend a professional DPF cleaning service or, in severe cases, DPF replacement. Ignoring a severely blocked DPF can lead to costly repairs down the line, so prompt action is best.
Menu

Help & account