The largest online repair guide library for every car

About us
Contact support
FAQ
Sign up
Sign in

DIY Cabin Air Filter Replacement on 2024 R1T Quad-Motor

0

Mike T. · rep 0 · May 25, 5:11 AM · 1 replies · solved · Question

Vehicle: 2024 Rivian R1T Quad-Motor

My 2024 Rivian R1T Quad-Motor is starting to get a bit of a stale smell in the cabin, especially when the AC is running. I'm thinking it's time to replace the cabin air filter.

Is this a DIY job on the R1T? I've done it on other vehicles before, but I'm not sure if Rivian has any quirks or special tools required. Where is the cabin filter located, and what kind of filter should I be looking for? Any step-by-step guidance would be super helpful!

✓ Accepted solution

ClearTheCode Admin

ClearTheCode Team · rep 0 · May 25, 5:11 AM

0

ClearTheCode admin answer:

Replacing the cabin air filter on your 2024 Rivian R1T Quad-Motor is a straightforward DIY maintenance task that can significantly improve your interior air quality and eliminate stale odors. Rivian generally designs these components to be accessible for owners.

1. Frequency of Replacement:

  • It's typically recommended to replace the cabin air filter every 15,000 to 20,000 miles or once a year, whichever comes first. However, if you drive in dusty environments or notice reduced airflow or odors, earlier replacement is advisable.

2. Location & Tools:

  • Location: On the Rivian R1T, the cabin air filter is usually located behind the glove compartment. This is a common placement for many modern vehicles.
  • Tools: You'll typically need minimal tools, possibly a small flathead screwdriver or a trim removal tool to gently pry open panels, and a T20 Torx bit or similar for small screws, depending on the exact trim panel design.

3. Step-by-Step DIY Guide:

  • Empty Glove Box: Remove all contents from your glove compartment to make access easier.
  • Access Panel Removal: Open the glove compartment. Look for screws or clips that hold the glove box assembly or a panel directly behind it in place. You might need to gently pull down or unclip a damper arm on the side of the glove box to allow it to swing further down.
  • Locate Filter Housing: Once the glove box is out of the way or fully lowered, you should see a rectangular plastic housing. This is the cabin air filter housing, often secured by clips or small tabs.
  • Remove Old Filter: Unclip or unlatch the housing cover. Carefully pull out the old cabin air filter. Note the direction of the airflow arrow on the old filter (usually pointing towards the rear of the vehicle or downwards) before removal.
  • Clean Housing (Optional): While the filter is out, you can use a vacuum cleaner to remove any leaves, dust, or debris accumulated inside the housing.
  • Install New Filter: Insert the new cabin air filter, ensuring the airflow arrow on the new filter points in the same direction as the old one. This is critical for proper filtration.
  • Reassemble: Close and secure the filter housing cover. Reinstall the glove compartment and any trim panels you removed, ensuring all screws and clips are properly fastened.

4. Filter Type:

  • Rivian uses a specific size and type of cabin air filter. You can purchase an OEM Rivian filter directly from a service center or parts department, or find a high-quality aftermarket equivalent. Look for filters that specify compatibility with the Rivian R1T (e.g., charcoal-activated filters can help with odors even more effectively).

5. When to See a Shop:

  • If you encounter any difficulty accessing the filter, or if you're unsure about the process, a Rivian service center can perform this task quickly. However, for most owners, this is a very manageable DIY job.
Menu

Help & account